Perfect Curls

Written by

The hair is not put under any tension and it takes just seconds to form a perfect curl. A beeper tells you when the curl is ready for release. With 3 temperature settings, 3 timer settings and the option to select the curl direction, you can use the different combinations to create a variety of styles from highly defined crisp curls to softer beachy waves. And by using different product, from hair spray to shine serum, you can further experiment with the final look. To see the RUSK® MiraCurl™ in action, click here.


Tips to achieve three very different looks with the RUSK® MiraCurl™:

Soft Curls Make sure you start the curls approximately 5-10cm away from the scalp depending on how long your hair is. Have the RUSK® MiraCurl™ on the low (190ºC) or medium (210ºC) heat setting for a softer result. First spray the hair with RUSK® Thermal Flat Iron Spray then curl the hair with the RUSK® MiraCurl™ section by section. Run your fingers through the hair from roots to ends to break the curls up. Finish with the RUSK® w8less Strong Hold Hairspray for lasting curls.

Soft to Medium Curls Use the RUSK® MiraCurl™ on either the medium (210ºC) or high (230ºC) temperature setting. If your hair is longer, lightly spray with RUSK® w8less Strong Hold Hairspray then use the RUSK® MiraCurl™ to curl the hair section by section. Small sections will give a tighter result. Once finished, lightly run your finger through the root area only, this will loosen the hair at the roots and leave the ends curlier. To finish off, use the RUSK® Thermal Shine Spray lightly and then the RUSK® w8less Strong Hold Hairspray for a lasting effect.


Strong Curls The key tip for a strong curl, is to take smaller sections and use the higher (230ºC) temperature setting. First lightly spray each section of hair as you go with RUSK® w8less Strong Hold Hairspray. Use the RUSK® MiraCurl™ to curl a section. Then pin that section in a rolled curl to the scalp, allowing the curl to cool down and set. Move onto the next section and repeat, pinning the curl to allow it to firmly set. Once you have finished all the sections give all the pinned curls another light spray of RUSK® w8less Strong Hold Hairspray and allow to set for 5-10mins.  Starting at the nape and moving up, remove all the pins. Lightly run your fingers through the root area without pulling through to the ends. Finish with the RUSK® Thermal Shine Spray lightly for that extra glossy look.

The new RUSK® MiraCurl™ is available nationally through leading salons and Hairhouse Warehouse.

RRP: $199.00